A Job That Took Three Setups to Get Right
The First Setup: Misalignment I had a job drilling a 20mm bore through a 300mm stainless steel block. The material was 316L, which is notoriously gummy and work-hardens at the cut zone if the tool rubs instead of shearing. The customer spec called for a positional tolerance of 0.1mm at the exit, a diameter tolerance of H8, and a surface finish of Ra 0.8 microns. Simple, right? I had drilled hundreds of holes through stainless steel. I set up the machine, aligned the guide bushing with the tailstock center, and started cutting. ...