Welding

Stress relieving before deep hole drilling removes residual stresses from the material. If these stresses are not removed before drilling, the part can distort when the material is removed from the bore area. I have seen this happen enough times that I now flag every new job for a stress relief review before I touch the machine. The underlying mechanism is straightforward. A part that has internal residual stresses is in a state of equilibrium. When I remove material from the center – which is what deep hole drilling does – that equilibrium shifts. The remaining material redistributes the stress and the part moves. In extreme cases, the bore comes out straight but the part bends around it. I have had parts that looked fine on the bore gauge but were visibly curved when placed on a surface plate. ...

When Repair Makes Sense Not every bad hole is scrap. I try to repair a bad hole before scrapping a high-value part, especially when the part is large, complex, or made from expensive material. Repairing a deep hole is almost always cheaper than scrapping a part that may have hundreds of dollars of material and hours of machining already invested. The decision to repair depends on three factors: how much material can be removed, how deep the defect extends, and what tools are available to reach the defect. I have successfully repaired holes up to 2 meters deep, but only when the right tooling was available. ...